PV Powered PVP2000 Spécifications télécharger pdf (Page 13)

PV Powered LLC 12 32-29-28-20-306

3.0 OPERATION

3.1 Start Up Procedures for the StarInverter

WARNING: Before turning on the StarInverter ensure that the front panel

is closed properly.

WARNING: The heat sink can reach temperatures in excess of 158º (70ºC).

Care must be taken to not touch the heat sink when in use. Nothing should be

placed on top of the heat sink.

Starting up the StarInverter requires the following steps in the order indicated below:

1. Turn the AC breaker ON.

2. Verify that a red LED light is illuminated.

3. (Optional step) Verify that communication is established with the PVP

Command Center (software on PC).

4. Remove the dark cover from the PV panels.

5. Check the polarity to make sure the + and – are wired correctly and confirm

that the PV panel open circuit voltage is at or below the level specified in Figure

6. Turn the DC breaker ON (If installed).

7. IT IS RECOMMENDED THAT YOU ATTACH A PADLOCK AT THIS TIME TO

PREVENT UNAUTHORIZED ACCESS OR DAMAGE TO THE INVERTER.

8. After 5 minutes, the StarInverter will start to produce power into the AC grid if

all necessary operating conditions are met.

3.2 LED Indicator Lights/Vacuum Fluorescent Display

LED INDICATOR LIGHTS

The StarInverter PVP3200, PVP2900 , PVP2800-XV and PVP2000 displays 2 LED indicator

lights visible through the upper left corner of the front panel. These lights will indicate the

StarInverter’s status.

If the StarInverter’s operating environment is safe to produce power into the AC grid, the

“OK” (Green) LED is illuminated.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Pas de commentaire

PV Powered PVP2000 Spécifications Page 13